city of detroit logo

DETROIT RESTAURANT INSPECTIONS

HOMEABOUT
This site is deprecated, please go to detroitrestaurantinspections.netlify.app to view the maintained site.

Edmonson Elementary School
1300 Canfield St. W.

Public School

StatusOpen
License typeFixed Establishment
State license number035008
OwnerDetroit Public Schools Communi
Complexity levelUnknown
Review frequencyEvery 180 days

21 Inspections
Since 8-1-2016

02-14-2023
Routine Inspection

OutcomeCompliant
0 violations cited

09-14-2022
Routine Inspection

OutcomeNot compliant
0 violations cited

05-25-2022
Routine Inspection

OutcomeCompliant
7 violations cited :
Code 7-204.11
Sanitizer(s) do not comply with law
FULL FOOD CODE:
Chemical SANITIZERS and other chemical antimicrobials applied to FOOD-CONTACT SURFACES shall meet the requirements specified in this code. (P)
Priority
Corrected on 5-26-2022
Code 3-501.16
Cold food item(s) stored above 41 degrees f
FULL FOOD CODE:
Except during preparation, cooking, or cooling, or when time is used as the public health control POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be maintained: (A) 135ºF or above, except that roasts properly cooked and cooled may be held at a temperature of 130ºF; or (P) (B) At 41ºF or less (P)
Priority
Corrected on 5-26-2022
Code 4-501.11
Equipment in poor repair
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 4-501.14
Warewashing equipment three compartment sink basins not cleaned before use
FULL FOOD CODE:
A WAREWASHING machine; the compartments of sinks, basins, or other receptacles used for washing and rinsing EQUIPMENT, UTENSILS, or raw FOODS, or laundering wiping cloths; and drainboards or other EQUIPMENT used to substitute for drainboards shall be cleaned as required.
Core
Corrected on 5-26-2022
Code 3-307.11
Food not protected from contamination
FULL FOOD CODE:
FOOD shall be protected from contamination that may result from a factor or source not specified under Subparts 3-301 - 3-306.
Core
Not corrected
Code 4-501.11
Equipment broken
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 6-501.11
Physical facilities in poor repair
FULL FOOD CODE:
PHYSICAL FACILITIES shall be maintained in good repair.
Core
Not corrected

10-05-2021
COVID19 SITE CHECK

OutcomeCompliant
0 violations cited

10-05-2021
Routine Inspection

OutcomeCompliant
0 violations cited

06-10-2021
Routine Inspection

OutcomeCompliant
0 violations cited

03-21-2021
COVID19 SITE CHECK

OutcomeCompliant
0 violations cited

11-09-2020
Routine Inspection

OutcomeCompliant
0 violations cited

11-01-2020
Routine Inspection

OutcomeCompliant
0 violations cited

03-13-2020
COVID19-phone-low

OutcomeCompliant
0 violations cited

03-11-2020
COVID19-temp closed

OutcomeCompliant
0 violations cited

09-22-2019
Routine Inspection

OutcomeCompliant
6 violations cited :
Code 3-501.16
Cold food item(s) stored above 41 degrees f
FULL FOOD CODE:
Except during preparation, cooking, or cooling, or when time is used as the public health control POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be maintained: (A) 135ºF or above, except that roasts properly cooked and cooled may be held at a temperature of 130ºF; or (P) (B) At 41ºF or less (P)
Priority
Corrected on 9-23-2019
Code 6-301.11
Soap at restroom handsink employee not provided
FULL FOOD CODE:
Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap. (Pf)
Priority Foundation
Corrected on 9-23-2019
Code 4-302.14
Sanitizer test kit quaternary ammonia not provided
FULL FOOD CODE:
A test kit or other device that accurately measures the concentration in mg/L of SANITIZING solutions shall be provided. (Pf)
Priority Foundation
Corrected on 11-10-2020
Code 6-501.11
Physical facilities floor s in poor repair broken
FULL FOOD CODE:
PHYSICAL FACILITIES shall be maintained in good repair.
Core
Corrected on 11-10-2020
Code MFL289.2129
Person-in-charge
FULL FOOD CODE:
Sec. 2129. (1) All food establishments shall employ a minimum of 1 managerial employee as a food safety manager, who must be an individual who is currently certified under a personnel certification program accredited by the American National Standards Institute, utilizing the Conference for Food Protection standards: (2) Beginning January 14, 2017 and every 5 years thereafter, a certified food safety manager who supervises the operations of a food service establishment shall have completed a food safety training program containing an allergen awareness component that has been approved by the department. A food service establishment shall retain records on the site of the food service establishment documenting compliance of its certified food safety managers with this subsection.
Core
Corrected on 11-10-2020
Code 4-501.11
Equipment in poor repair
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Corrected on 11-10-2020

04-24-2019
Routine Inspection

OutcomeCompliant
2 violations cited :
Code 4-501.11
Equipment in poor repair
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Corrected on 9-23-2019
Code 6-501.11
Physical facilities floor s in poor repair broken
FULL FOOD CODE:
PHYSICAL FACILITIES shall be maintained in good repair.
Core
Not corrected

11-13-2018
Routine Inspection

OutcomeNot compliant
6 violations cited :
Code 6-301.11
Soap at restroom handsink employee not provided
FULL FOOD CODE:
Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap. (Pf)
Priority Foundation
Corrected on 11-14-2018
Code 4-302.14
Sanitizer test kit quaternary ammonia not provided
FULL FOOD CODE:
A test kit or other device that accurately measures the concentration in mg/L of SANITIZING solutions shall be provided. (Pf)
Priority Foundation
Not corrected
Code 4-903.11
Single-service/single-use article(s) exposed to dust splash or other contaminates
FULL FOOD CODE:
Cleaned EQUIPMENT and UTENSILS, laundered LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES shall be stored in an approved manner and location.
Core
Corrected on 11-14-2018
Code 6-501.11
Physical facilities floor s in poor repair broken
FULL FOOD CODE:
PHYSICAL FACILITIES shall be maintained in good repair.
Core
Not corrected
Code 4-204.112
Thermometer(s) refrigeration not provided
FULL FOOD CODE:
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display (EXCEPT, heat lamps, cold plates, steam tables, or other equipment where it is not practical). (C) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (D) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1C or 2F in the intended range of use. (Pf)
Core
Not corrected
Code 3-305.11
Food item(s) in storage exposed to dust splash or other contaminates
FULL FOOD CODE:
FOOD shall be protected from contamination by storing the FOOD: (1) In a clean, dry location; (2) Where it is not exposed to splash, dust, or other contamination; and (3) At least 15 cm (6 inches) above the floor, unless otherwise approved.
Core
Corrected on 11-14-2018

11-08-2018
Routine Inspection

OutcomeCompliant
0 violations cited

10-08-2018
Complaint

OutcomeCompliant
0 violations cited

06-08-2018
Complaint

OutcomeCompliant
0 violations cited

04-15-2018
Routine Inspection

OutcomeCompliant
4 violations cited :
Code 4-501.11
Equipment broken
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 6-501.11
Physical facilities floor s in poor repair broken
FULL FOOD CODE:
PHYSICAL FACILITIES shall be maintained in good repair.
Core
Not corrected
Code 4-501.11
Equipment in poor repair
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 4-204.112
Thermometer(s) refrigeration not provided
FULL FOOD CODE:
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display (EXCEPT, heat lamps, cold plates, steam tables, or other equipment where it is not practical). (C) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (D) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1C or 2F in the intended range of use. (Pf)
Core
Not corrected

10-15-2017
Routine Inspection

OutcomeNot compliant
8 violations cited :
Code 4-702.11
Clean utensil(s) and food-contact surface(s) not sanitized
FULL FOOD CODE:
UTENSILS and FOOD-CONTACT SURFACES of EQUIPMENT shall be SANITIZED before use after cleaning. (P)
Priority
Corrected on 4-16-2018
Code 3-501.16
Cold food item(s) stored above 41 degrees f
FULL FOOD CODE:
Except during preparation, cooking, or cooling, or when time is used as the public health control POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be maintained: (A) 135ºF or above, except that roasts properly cooked and cooled may be held at a temperature of 130ºF; or (P) (B) At 41ºF or less (P)
Priority
Corrected on 10-16-2017
Code 3-202.15
Food package(s) cans dented dented on seam or swollen
FULL FOOD CODE:
FOOD packages shall be in good condition and protect the integrity of the contents so that the FOOD is not exposed to ADULTERATION or potential contaminants. (Pf)
Priority Foundation
Corrected on 10-16-2017
Code 4-501.11
Equipment broken
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Corrected on 10-20-2017
Code 4-501.11
Equipment in poor repair
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 4-204.112
Thermometer(s) refrigeration not provided
FULL FOOD CODE:
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display (EXCEPT, heat lamps, cold plates, steam tables, or other equipment where it is not practical). (C) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (D) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1C or 2F in the intended range of use. (Pf)
Core
Not corrected
Code 4-501.11
Expand for full food code definition
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected
Code 4-501.11
Equipment components broken
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected

05-16-2017
Routine Inspection

OutcomeNot compliant
2 violations cited :
Code 4-702.11
Clean utensil(s) and food-contact surface(s) not sanitized
FULL FOOD CODE:
UTENSILS and FOOD-CONTACT SURFACES of EQUIPMENT shall be SANITIZED before use after cleaning. (P)
Priority
Not corrected
Code 4-501.11
Equipment broken
FULL FOOD CODE:
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
Core
Not corrected

11-14-2016
Routine Inspection

OutcomeCompliant
0 violations cited
About inspections
A restaurant is compliant when zero Priority or Priority Foundation violations are cited during an inspection, or when all are corrected; Core violations will be reviewed at the next routine inspection and are not required to be corrected to be in compliance.
Built using open data | Last updated 2023-04-25